WELCOME TO GSM VIJAYAWADA

PLEASE.......REGISTER VALID E MAIL

DONT POST SPAM CAREFULL......

Join the forum, it's quick and easy

WELCOME TO GSM VIJAYAWADA

PLEASE.......REGISTER VALID E MAIL

DONT POST SPAM CAREFULL......

Would you like to react to this message? Create an account in a few clicks or log in to continue.

    Nokia 500 Earpiece Speaker 100% Solution

    ashiq20
    ashiq20


    Posts : 7
    Reputation : 5
    Join date : 2012-04-16
    Location : dhaka

    Nokia 500 Earpiece Speaker 100% Solution Empty Nokia 500 Earpiece Speaker 100% Solution

    Post  ashiq20 25/4/2012, 10:27 am



    [center]
    This solution covers for Earpiece Speaker problem on Nokia 500 with a
    3.2 inches display, TFT capacitive touchscreen phone and runs in
    Symbian Anna OS. If somehow when the speaker goes wrong and no
    indication of any audio can be heard over the speaker during when a call
    has made. This may sometimes happens due from like wet or water
    damages, and any accidental damaged that might cause the speaker stop
    working.

    This solution provides some simple
    hints on how to fix it, just take a minute to analyze and locate the
    speaker parts and the entire connection on the PCB board as shown on
    the solution image below.
    nokia
    GsmAngel Nokia 500 Earpiece Speaker Repair Solution
    Hints in troubleshooting Nokia 500 Earpiece Speaker

    1. Start to check with Speaker assembly, it is located at the top of the board behind the LCD screen.
    2. Check for possible corrosion build ups, speaker terminal bending.
    Clean it including the speaker terminal pads or aligned it again if
    either the connection might be weak.
    3. Check the speaker using a multimeter. Set the tester to X1 and check
    if there is crackling sound can be heard and the tester responds. If no
    indication of anything, the speaker is already burned out or damaged.
    Replace it at once.
    4. If the speaker is okay, and still there is no sound can be heard, check the firmware. Update it or do re-flash.
    5. If the problem still exists, the possible faulty is the GAZOO ASIC
    chip. The only solution for that is to rework or replace it if necessary
    and that's need a good soldering skills to do it.
    Warning: If you do not have much
    skills on how to to re-ball or install a BGA chip, just leave it to the
    experts. Attempting to touch that chip without expertise will cause the
    phone dead in no time. [/center]

      Current date/time is 29/3/2024, 2:40 pm